Tennessee · Hiking · Near Red Bank

Flipper Bend Access Trail

1.9 mi
round trip
680 ft
climb
1,904 ft
high point
Out and back
route
Mar–Jun, Sep–Nov
best months

Clear at last check

Weather is good · OpenWeather · checked 19 h ago

Loading this week's forecast

Flipper Bend Access Trail is an easy out-and-back hike in Tennessee, about 2.6 miles from the town of Falling Water. The trail is roughly 3.8 miles long, with a steady climb that reaches a high point of 1,904 feet. The route starts at about 1,866 feet and ends at the same elevation, so the total gain and loss are each about 680 feet. The steepest stretch comes early, around 0.44 miles in, with a grade of about 9 percent. Spring and fall are the most comfortable times to go. Typical averages from a nearby weather station show October highs around 70°F with lows near 47°F, and April is similar at about 71°F by day and 47°F at night. That station sits a few hundred feet lower than the trail's high point, so temperatures on the higher ground run a little cooler. The hike takes about 1.5 hours. Flipper Access Trail Bend lies just 0.1 mile away, and Flipper Bend and Clear Branch Loop Trail are each about 1.6 miles off. Climbers can find North Chick Gorge, Soddy TN, about 2.4 miles away.

Around this trail

Add any of these when you start a trip
  • Sleep close

    Holly Branch Campsite

    Campground

    Campground · 1.9 mi from the trail
  • Eat after

    Scottie's Diner

    Restaurant

    Open after 6
  • If it rainsTVSRR at English Wikipedia . Photo by Jason Trew / TVSRR, Public domain · Wikimedia Commons

    Tennessee Valley Railroad Museum

    Museum

    Museum · 12 mi from Red Bank

    Railroad museum in Chattanooga, Tennessee

Places © OpenStreetMap contributors · Photos: TVSRR at English Wikipedia . Photo by Jason Trew / TVSRR, Public domain (commons)

More in Red Bank

Map and trail data © OpenStreetMap contributors